2025 Polaris Xpedition?
- Thread starter King-Lars
- Start date
RNBJones
Member
We are testing clutch set up for best performance with less noise .
tarkenton09
Member
Heck yea! Keep me up to date!
Qwahetace
New member
I had this done along with 32in Maxxis Liberty tires. Much improved low end RPM. Feels like it lowered by 1.5-2k rpms. Feels more like my RZR felt. Top end in sport mode is still fast in my opinion.
Attachments
DallasO
Member
I have the AA clutch kit and will not be going with Polaris clutch weights. I did put 32" Rock A Billy tires on. Each helped a little and both helped a lot with the noise issue. But what fixed the problem of noise was a Rugged Radio with intercom and a good set of headsets. I will not buy Rock A Billy tires again. I just returned from a week in Kanab UT, and driving to and from the trail heads was quite a bit of highway miles. They a very squirrely on pavement, (the center two rows of tread are taller the the rest of the tire face). That is the only part of the tire that is 32". I did not have any problem with the tires or the Xpedition on all the sand trails.
f150harley
Member
Installed the Polaris service advisory clutch after riding with the stock clutch for a couple of months and an after market performance clutch for a couple of months. Now it's like a whole new driving experience. I'm TOTALY happy with it for my driving style. Yes, the lower RPM clutch gives you the benefit of noise reduction given lower RPM's from the engine. And for me given my style of driving I benefited from a dramatic increase in fuel mileage. Prior to installation of new clutch I could almost visually watch the fuel gage go down. Now, I became concerned that the gage was staying on full and wondered if the gauge was faulty. Noticed a smoother start from a stopped position as well. It's a whole new machine.
I picked up my xp5 last Tuesday. It had a build date of 2-26-24 it has the new clutch from the factory. I’m told that Polaris has been installing the new clutch as of 2-5-24. Still pretty quick but don’t know what the old clutch would have done.
Any findings?
RNBJones
Member
Used a bikeman clutch kit . Lowered rpm’s to 4500 at 20 mph . It has a tune from Pandemic . You can go to force turbo site for specs . I am adding all my options which brings me up to 3,300 pounds with use in it . Front is 700 pounds lighter than back . You can see my video on my turbo coming post .
Revo45
New member
Not sure if this helps anyone. I got my weight kit installed and picked it up today. Lost a little top end but not much. It’s maybe a couple decibels quieter but it doesn’t seem to have much of an effect on the noise level. I’ve heard some of the later vehicles came with sound dampening on the back wall from factory…mine does not have this.
Attachments
RNBJones
Member
johndeerefarmer
Well-known member
What are they bolted too, or they just wrapped around the bar behind the seat? ThanksThought I would add some 4 point protection with the Turbo .
RNBJones
Member
I put a 2x3 x3/8 aluminum angle across welded to brackets I fabricated from existing roll guard .
RNBJones
Member
Yes they are bolted to angle .
XPEDITION Forum Photos
XPEDITION Forum Photos
Similar threads
Latest Discussions
-
-
-
Shout out to High Desert Unlimited
- Started by Dale's Snake Pit
- Replies: 3
-
-
Xpedition Forum Classifieds - Warning/Rules/Disclaimer- Started by super8
- Replies: 0