Is the Polaris Lock & Ride Poly Windshield supposed to be water tight?

[Panhandle XP]

New to this site and new to sxs (only quads before).
I just installed the L&R Poly Windshield on my new XP and after washing it, a lot water entered the cab. Is this expected on the L&R poly windshields and if so, is there any adjustments you can do to lesson it? There really wasn't much water pressure to get the water in the cab and it entered both at the top and bottom. Just wondering if i shouldn't be driving it in the rain now :-/.

 

[Ryan]

Sorry, I'm of no help here but my dam glass windshield isn't watertight. lol

 

[Panhandle XP]

Sorry, I'm of no help here but my dam glass windshield isn't watertight. lol

Good to know...and misery loves company

 

[JTBarlow]

It definitely shouldn’t let water flow freely past it.
I would check all 4 sides and make sure the edge gasket is sitting as evenly as possible on the frame and lower sill. And also check the clamp bolts and make sure they’re all properly tightened. (Careful not to over-tighten them, as it can damage the windshield or clamps.)

 

[B B]

My glass windshield leaked like sieve. I took it to the dealer and they moved some stuff around along with some added silicone and it's 99% sealed. It still leaked a little around the windshield wiper motor, but nothing like it was.

 

[attakracer]

Sorry, I'm of no help here but my dam glass windshield isn't watertight. lol

Mine either !!!! Glad I spent 45 Grand to still get wet inside when its raining out !!!!!!

 

[Panhandle XP]

I took it to the dealer and they said they put an additional seal on it. Not better. I’ve just been driving around with a towel when it’s raining.