dogtiredhiredguy
Member
Is it supposed to be sticking out past the roof? The passenger side tucks under when the door is closed.
Driver door upper seal
- Thread starter dogtiredhiredguy
- Start date
Is it supposed to be sticking out past the roof? The passenger side tucks under when the door is closed.
dogtiredhiredguy
Member
- Thread starter
- #2
Clayton
Active member
Door will need a small adjustment . The seal shouldn’t be sticking out.
Badger203
New member
The gaskets are attached to the door with adhesive backing. If the door is lined up the whole way around, it may just be the gasket needs aligned a little better.
When I saw this post I went and took a look at mine and my driver’s door gasket was a little funky. A little manipulation and it’s fine now.
I just had both door panels off this week for sound deadening. Not the doors, just the panels. If the door closes and latches OK, try aligning the gasket first. Just my .02 worth.
When I saw this post I went and took a look at mine and my driver’s door gasket was a little funky. A little manipulation and it’s fine now.
I just had both door panels off this week for sound deadening. Not the doors, just the panels. If the door closes and latches OK, try aligning the gasket first. Just my .02 worth.
dogtiredhiredguy
Member
- Thread starter
- #5
Thanks I’ll try adjusting the gasket since the door closes and latches fine. Did you loosen the torx at the top above the window to move it I assume or is it just adhesive?
Badger203
New member
Just pulled and reapplied no torx needed for the gasket.
XPEDITION Forum Photos
XPEDITION Forum Photos
Latest Discussions
-
-
-
-
-
Xpedition adv in Idaho canyon county area
- Started by axial510
- Replies: 2