Recent content by TBluth

I just received antenna mount from you. Easy install, looks and fits great! It’s nice finding products that fit right and they are not high priced machined flashy billet parts. Oh, and the unexpected coozie with the parts was a great addition and will definitely get used! Thank you!

I have not done any sound deadening

My 24 XP5 came with the Polaris quiet clutch kit, I ended up going with Aftermarket Assassins Cruiser clutch kit. It’s quieter at cruise part throttle speeds. Then I added their dual suppressor muffler and stage 2 tune. I’m happy with the end result.

I also have Aftermarket Assassins ecu tune, clutch kit and dual muffler. The whole set up is a big improvement over stock.

I installed switch up in wiper motor. Works great. Easy install

I own one and it stays on trailer with my trailer spare. I Carry gluetread kit and compressor.

I’ll take it

I been thinking about that for my xp5. I would think if you measured the compressed length and extended length of shock that is currently on bed, you can get an electric actuator with same stroke and install it with a switch. You will need to pick the load you want it to pick. Shouldn’t be that...

They worked great and easy install. Time consuming but easy.

I installed a heated seat kit from Rocky Mountain ATV in my stock seats on my RZR XP 1000. Removed all the staples installed kit and re stapled with stainless staples. I would assume seats are built same but I can look at the backs of my Xpedition when I get home in a couple days.

I carry the glue tread kit. It has sidewall patches, plugs, valve stems and all to repair a tire minus the air to fill it. I’ve used sidewall patch on my stock pro armors and still holding after 100+ miles. I keep a spare with my trailer just in case

I just installed 2” RPM seat risers and have stock mirrors. No issues at all.

I’m wiring the cooler up this weekend and will report back. I really like the slider, pretty solid unit. Heavy duty slides, locks when in, mid way out and fully out. Rated for 500lbs. Purchased from Atomik UTV.

It is straight forward, they basically bolt to windshield hinge bolts (if you have hinged windshield) as you loosen bolts , the windshield will start to slide upward a little. It helps to have a 2nd hand to help pull down on windshield as bolts get tightened to keep the seal tight in lower corners.

Got some time to add some parts this weekend. AJK bedslide, AJK rack, couple Milwaukee Packouts for storage, Phillips 12v dual zone cooler, Valor Alpha H1 32 x 10 x 15 tires. The windshield tint was right in eyeliner going down hills so I pulled it off and added Polaris visors. Time to go test...